Flat-rate tune-ups: gas fireplace $89, furnace $150, tankless flush $150, plus GST See what’s included

    Blue Heron Plumbing and Heating, Victoria BC
    Call (250) 888-5922

    Plumbing

    What a Pressure Reducing Valve Does, and How You Know It Has Failed

    October 20, 2026 · Jayden Svenhard, Blue Heron Plumbing and Heating · 4 min read

    Pressure gauge and yellow-handled ball valve on a household water line

    There is a component in most houses that almost nobody can name, that has a service life, and that causes a scattered set of expensive problems when it goes (usually without anyone connecting them to each other).

    That is the pressure reducing valve, or PRV. It sits on the incoming water line, and its job is to take municipal supply pressure and bring it down to something your plumbing was designed for.

    Why it exists

    Municipal water arrives at a pressure set for the network's needs, not your house's. Depending on where you are and how the system is laid out, that can be considerably higher than residential plumbing is built to handle.

    Household plumbing, fixtures and appliances are generally designed around a much lower working pressure. Run them consistently above it and nothing dramatic happens on day one: things just wear out faster, seals fail sooner, and the system is under strain every minute of every day.

    The PRV is the component standing between those two numbers.

    The symptoms, and why they look unrelated

    This is what makes PRV failure hard to spot. The symptoms turn up in different rooms, at different times, and each one looks like its own separate small problem.

    • Taps that drip and keep dripping after being repaired
    • Banging or hammering in the pipes when a tap or appliance shuts off
    • Fixtures failing repeatedly: cartridges and seals going again a few months after replacement
    • The hot water tank's temperature and pressure relief valve weeping or discharging
    • Toilet fill valves failing more often than seems reasonable
    • Unusually forceful flow at taps, or a shower that has become uncomfortable
    • Appliance inlet valves failing: dishwashers and washing machines

    The hot water tank relief valve is the one worth knowing about. People replace that valve, it weeps again, they replace it again, and the valve was never the problem. It was doing its job, which is to relieve excess pressure. The pressure was the problem.

    The other direction

    A PRV can also fail the other way, sticking closed or partly closed, which shows up as low pressure through the whole house. Everything works, just weakly, everywhere at once.

    The useful diagnostic distinction: pressure problems at one fixture are usually that fixture: an aerator, a cartridge, a partly closed shut-off. Pressure problems at every fixture point at the main, and that means the PRV or the supply itself.

    They have a service life

    A PRV is a mechanical component with an internal diaphragm and spring, and those do not last forever. They are generally expected to last a number of years rather than the life of the house.

    Which leads to the practical point: if your house is not new and the PRV has never been replaced, it is worth checking. Not because it has definitely failed, but because it is a cheap component whose failure quietly costs money everywhere else in the system. This is particularly worth knowing in older housing stock: a lot of Oak Bay, Fairfield and older Saanich homes have original components that have been quietly working for decades.

    Is it always the PRV?

    No, and it is worth being straight about that. Some houses do not have one. Some pressure complaints are the supply itself. Some are a partly seized main shut-off restricting flow, which looks like low pressure and is a different repair.

    Checking is quick: the pressure gets measured, and that number answers the question immediately rather than by elimination.

    Getting it checked

    Call or text (250) 888-5922 and describe what you are seeing. If several fixtures are misbehaving in similar ways, mention that: it is usually the clue.

    Estimates are free and you will have an agreed price before work starts. Blue Heron is owner-operated: Jayden is a Journeyman Plumber and Class B Gas Fitter with eleven years in the trade. Reachable 8:00am to 8:00pm, seven days.

    Serving Victoria, Saanich, Oak Bay, Esquimalt, View Royal, Colwood, Langford, Sooke, Sidney and the Saanich Peninsula.


    CallText